This is the latest in dermatological advances in microdermabrasion . It is used to resurface a less than perfect facial surface. The definition of resurfacing is to remove the upper portion of skin in order to get rid of flaws such as wrinkles, blotchiness, acne scarring, and discoloration. Various methods are available to do just that, including chemical peels, laser treatments, dermabrasion and microdermabrasion.
This process is similar to its heavier handed relative, dermabrasion. Both work in re-planning the face by wearing away its upper layer of skin with some sort of abrasive substance. While dermabrasion relies on a high speed rotary machine, microdermabrasion often utilizes crystals to remove the flawed surface. This method uses a tool with a sapphire head to sand away the desired surface areas. There are actual sapphire particles on the abrasive portion of this medical device.
The tool vibrates in order to provide the specific grit needed for each particular patient. It can be adjust to offer fine, medium or deeper results. This process is combined with a dose of red and blue pulsed L.E.D. light therapy and is performed using the following steps:
First the sapphire tool is used in an exfoliation process.
The above process would be repeated but this time with a soothing gel that is rich with vitamins.
A lymphatic massage is performed using the tool, as well, which removes toxins and promotes better circulation.
Red L.E.D. light (red monochromatic light) is applied which helps to firm up skin and to enhance collagen production in order to increase elasticity. The red light tends to rev the skin up.
Blue L.E.D. light therapy is used to get rid of bacteria and to increase the flow of oxygen to the area. This light treatment has become very successful in treating acne. The blue light helps to calm the skin and induce healing.
This treatment takes approximately six to ten sittings for its full effects to be seen. It is recommended that the procedures be done every week or every other week, depending on the individual case.
This procedure is performed in a dermatologist's or plastic surgeon's office and takes about forty-five minutes to complete. The process is reportedly pain-free. There will be a progression of improvement over the weeks as each treatment takes place.
If you are interested in the Sapphire 3 Microdermabrasion treatment performed on your face, call your dermatologist or plastic surgeon to inquire whether they are up on this revolutionary tool. Then make an appointment to see if this method will work for you.
![[Valid RSS feed]](http://www.massagebyben.com/articles/images/icon_Rss.png "XML Feed For RSS"){kind=icon}
Category Rss Feed
Print This Article
Add To Favorites 